CRACO C20 Dispensing pump – 2022

Specifications

– Pneumatic Motor: NXT
– Compression ratio: 68:1
– Maximum outlet pressure: 434 Bar
– Volume per double cycle: 200 cc
– Flow rate at 60 cycles/min.: 12 L.P.M.
– Pump Body: Check-Mate L200

1 x Data Track system included in the equipment with the following features:
– Monitoring of material consumption and volumetric flow
– Diagnoses the pump (When should the preventative pump maintenance)
– Cut off the air supply to the pump in case of rupture of hose or lack of product in the drum (detects sudden acceleration of the pump and cuts off the supply air.
– This system is Stand alone and has no communication options.

2 x Product pressure regulator, pneumatically actuated with pressure gauge, the regulator is used to eliminate pressure spikes caused by the pump and maintain
constant pressure at the gun inlet, avoiding variations in flow rate during application,

Technical characteristics:
– Maximum air pressure: 7 Bar
– Maximum product pressure: 344 Bar
– Regulating pressure: 17 – 310 Bar
– Product entry: 3/4”
– Product Output: 3/4”

2 x Automatic gun, model 1K-Ultra Lite, for extrusion, robot mounting, supports one maximum pressure of 276 bar.

This pistol to operate requires air to open and of air to close, uses a double-acting cylinder,
Therefore, the robot must have a pneumatic valve 4/2 to reverse the direction of air in the gun piston.
(customer responsibility)

1 x Extrusion nozzle 1.17 mm diameter
1 x Extrusion nozzle 2.28 mm diameter
1 x Extrusion nozzle 3.96 mm diameter

Note: All hoses are Teflon coated to prevent the product from drying out in the interior.